SELF LOCKING SHAFT
This is a shaft designed to support gears or pulleys in any drive mechanism. It is self locking by virtue of a split collet on one end tensioned by a taper cone and bolt.
Bore your housing to fit the large and small end, then on the large end simply tighten the bolt against the tapered cone and it expand the end of the shaft to lock it in place. No threaded ends or spacers required to set this shaft into the perfect location.
SHAFT OVERALL LENGTH 94 MM
SMALL END 12 MM DIAMETER X 15 MM LONG
BEARING AREA 16 MM DIAMETER X 59 MM LONG
COLLET END 20 MM DIAMETER X 20 MM LONG
BOLT 8 MM X 1.25
CONE 8.5 MM LONG TAPERS FROM 16.8 TO 15.8 MM
10 other products in the same category: